Mechanical design

Design method and mechanisms in the first fall, then manufacture from both ends: additive on one side, forming and industrial finite elements on the other.

Requirements, checked against this list

Computed from the courses above, not asserted. If the catalogue changes and a route stops clearing the bar, this panel says so.

Core courses6 of 6
Fluids2
Solids2
Systems2
Advanced lab1

Weekly hours across the route34

Clears the requirements

Take this route if

You want product development, machine design, or the Israeli additive-manufacturing cluster. It is the broadest route in employer terms and the one that transfers best outside engineering proper.

What you need before it starts

Linear algebra, Rigid body dynamics and Mechanics of solids 1. Engineering design only needs the first, which is why it can sit in the third-year fall.

Where it lands you

Product development engineer, machine designer, manufacturing or process engineer, additive manufacturing engineer. For research it points at design theory, optimisation and manufacturing processes.

What will bite

This is the lightest route in hours, which leaves room. Inventive design is a two-hour elective that pairs with it naturally, and the applied project converts into a job more often than anything else in the catalogue.

Someone in the club has taken every one of these.

A route on a page is worth less than ten minutes with a student who took the course last year. That is the part you get by joining.

Join CARNOT Every course, unfiltered

These routes are ours. The university did not publish them and does not endorse them. Semesters and prerequisites come from the faculty elective presentation, and courses with no fixed semester are placed where the load allows. Check any route against the official handbook and the live timetable before you register on the strength of it.

Mechanical design

Year 3

Year 3

Year 4

Year 4

Someone in the club has taken every one of these.